Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-04-2003, 10:08 PM
|
#5 |
|
Registered Member
Join Date: Nov 2001
Location: Sunny, Hot, Sebring, Florida
Posts: 725
|
Brakes
How about the master cylinder then? Can you pump up pressure, hold it, and the pedal sinks?.....that is usually a master cylinder or a leak at the caliper, there are brass washers that seal the banjo bolt at the caliper, did you mess with those, look for a leak on the inside of the wheel.
Also, this car doesn't have an adjustable brake bias knob that your not aware of does it? Are you sure your calipers are not leaking? Bad/leaky brake line(s)??? Are the rears really wasted???????? yank your ebrake and see how the rears feel, or if you can take a look. Vacuum leaks maybe????????? Other than that, I'm lost. Good luck, Camaro's suck! Jay
__________________
Remember...2nd place is 1st place for losers! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| brake problems ??? | Rodoggx | Windsor Power | 2 | 04-27-2004 04:54 AM |
| Brake problems | 84GT350-1 | Windsor Power | 1 | 12-28-2003 08:02 PM |
| Brake Problems | arivera | Small Ponies | 3 | 04-24-2003 04:02 PM |
| Brake Problems | gtnby2 | Windsor Power | 4 | 04-05-2003 05:47 PM |
| Brake Problems | ddawson | Corner Carvers Delight | 1 | 02-03-2000 08:39 AM |