Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-13-2001, 11:00 PM
|
#11 |
|
Registered Member
Join Date: Jun 2001
Location: KC,Mo,US
Posts: 70
|
There is a rubber noise dampener that is on a stock shifter, when I put my tri-Ax in. In order to put it in the lowest position you had to remove the noise dampener. The instruction said that you would hear alot more tranny noise if you didn't replace the noise dampener.
------------------ 95gt 80k, MSD 6AL, MSD coil, pulleys, fpr, cold air kit, off road h-pipe, flowmasters, 3.73, fluidampener, 9mm wires, mega bite jr lowers, kennybrown subframe connectors, edelbrock performer intake, 70mm TB, Aluminum Driveshaft. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tranny swap? | 03stangGT | Modular Madness | 7 | 11-19-2006 08:57 AM |
| Yet another tranny fluid ?? | Simi Stang | Windsor Power | 4 | 09-30-2003 12:44 PM |
| What would cause an auto tranny to whine in first gear? | BennettDMB13 | Modular Madness | 4 | 06-24-2003 05:34 PM |
| Tranny update...Lentech VB | silver_pilate | Blue Oval Lounge | 10 | 05-02-2002 12:34 PM |
| This is bad! Did my Uncle cause my Racing tranny to overheat?(It's a long 1... sorry) | Stang_ROTY | Windsor Power | 1 | 08-30-2001 10:55 PM |