Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-21-2003, 12:48 PM
|
#3 |
|
Registered Member
Join Date: Oct 2001
Location: Florida Keys
Posts: 593
|
Ha, yeah I realized thats about the worst job for a parking lot. I managed to fabricate a throttle cable out of some light cable used for fishing, and some crimps though, it actually works quite well until I get the new cable. I appreciate your help though, did it just slide off back towards you, or is it slotted? I cant really get my head in position for a good look at it, so Im just going by feel. If I had tools I would probably just rip the damn seat out. Thanks again.
__________________
89 notch-finally not stock!! ported gt40's, ported cobra intake, 65mm tb, 75mm maf, mac cai, lt's,prochamber, fms 1.6 rr, 125 shot. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| throttle cable removal on an 88 lx 5.0 | c3racer2000 | Windsor Power | 5 | 02-10-2003 12:45 PM |
| need a throttle cable.... | 71grande | Classic Mustangs | 1 | 01-12-2003 07:06 AM |
| Aod Tv Throttle Cable | pete1 | Windsor Power | 1 | 04-29-2001 02:47 PM |
| Custom throttle cable plate??? | leo | Windsor Power | 2 | 03-30-2001 08:01 PM |
| Throttle Cable hook up | Ponch65 | Classic Mustangs | 2 | 05-06-2000 02:48 PM |