Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-05-2003, 01:12 AM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: Nebraska
Posts: 86
|
Fuel pump. There is not too much fuel, there is not enough. Change the fuel filter, if that doesn't help you might want to change the pump. But you need to get a reading on the fuel pressure when you first turn the key to the "on" (primes the system) position before starting the motor. It should without delay shoot up to at least 38psi immediately. If not you may have cloged filter or weak pump.
__________________
Proud RHC member #99 1990 Mustang GT Trick Flow heads,F303,Mac cold air,FMS 65mm tb,73mm ma,FMS 1.6,GT-40 intake,MSD igintion,NOS Big Shot@150,Mac equal shorties,Mac h-pipe,American Thunder flows,Centerforce dual friction,TTC 3550,alm drive shaft, 3.73's, HPM subframes, k-member brace, strut tower brace.. amongst others. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with RPM's | cgg074 | Modular Madness | 2 | 09-29-2003 10:12 PM |
| Motor breaking up past 3000 rpms. Gurus I need your help!!! | Miguel | Windsor Power | 0 | 08-13-2002 08:08 AM |
| initial startup problem, and now it falls flat on its face | fiveohpatrol | Windsor Power | 2 | 08-09-2002 01:24 AM |
| Replacing convertible top. How hard is it? | Dark_5.0 | Windsor Power | 7 | 06-09-2001 09:01 PM |
| Help!!1Nasty Driveline vibrations above 2800 rpms | goduke | Windsor Power | 2 | 01-29-2001 12:54 AM |