Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2001, 09:55 PM
|
#3 |
|
Registered Member
Join Date: Nov 2000
Location: So. Cal.
Posts: 244
|
You might want to heli-coil it. Just break the little tab off at the bottom of the heli-coil and the bolt will pass right thru. That way you only have to drill the stripped hole.
------------------ 347, 279/284 .493/.510, TFS TW, Stealth, 750, Flowtech hdrs, Dr. Gas X, 2 Chmbr Flowmaster, MSD 6AL-Dist.& SS coil, Art Carr C-4, Currie 9" w/3.55, alum Drv Shft, susp mods, 4 wheel power disc In a 66 coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Urgent.....read This!!! | Kevin Price | Blue Oval Lounge | 15 | 02-05-2003 01:11 PM |
| URGENT Suggestions on Bearings & Rings | jim_howard_pdx | Windsor Power | 3 | 09-24-2002 09:12 PM |
| MAC Pullies OK, or would you recommend another? (a little on the urgent side) | 95mustanggt | Windsor Power | 3 | 05-24-2002 10:05 AM |
| URGENT!! Senate Bill S1766 to call for scrapping of cars 15 years or older | 89FHPLX | Blue Oval Lounge | 13 | 02-09-2002 07:06 PM |
| Just Got gear installed!!!! Urgent | JamGtStang | Windsor Power | 9 | 04-17-2001 08:50 AM |