Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-10-2001, 03:54 AM
|
#1 |
|
Registered Member
Join Date: Aug 2000
Location: Hallandale Beach, FL, USA
Posts: 92
|
Thanks for the reply !
i was wondering if you knew which jets to use if i wanted to go one step leaner than stock jetting... i have a NASTY bog under 3500 rpms.. and i also have a crane 2040 cam, which is the exact same grind as an E303 FMS cam and comp cams racing valve springs...... i have a torker II, 302 intake.. and shorty headers with off-road h-pipes and 2 chamber flowmasters with dumps, a 5 speed nad 4.10 gears with FMS drive shaft... eibach drag springs... jetting suggestions ? |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock Carb | Elvis | Classic Mustangs | 5 | 08-31-2004 10:31 AM |
| 600CFM Edelbrock carb | 7SecYaRight | Windsor Power | 8 | 10-09-2003 01:23 AM |
| Generic Rebuild kits for Edelbrock 750 carb | SuperIrish | Windsor Power | 3 | 05-10-2003 01:07 AM |
| Edelbrock Carb Flooding, HELP? | 429mustang | Windsor Power | 6 | 04-06-2003 07:21 PM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |