Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-23-2003, 01:45 PM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: The Midwest
Posts: 79
|
Thanks!
You can buy the springs through Ford although they are a bit more expensive. I picked these up from Gene Evans Racing in GA (www.gefracing.com) but they can also be had from Jim at PPI. I paid about $150+shipping whereas they will go for about $185 at the dealer. In any case, they are great springs and with the linear rates (600 & 250), the ride is great! Ford part #'s: Front: 1R3Z-5310-CA Rear: 1R3Z-5560-AA |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| stocks springs vs. lowering springs | GhettoPop | Windsor Power | 1 | 02-12-2004 07:08 PM |
| Bullitt Springs in '99 Cobra?? | daveGT | Modular Madness | 3 | 06-03-2003 02:43 PM |
| H&R springs or Eibach?? (replaing my Jamex Springs) | KB94GT | Modular Madness | 0 | 05-14-2002 07:44 PM |
| Bullitt...all show and no go!! | MS54 | Modular Madness | 4 | 09-06-2001 12:45 PM |
| Springs | MDM | Windsor Power | 0 | 04-11-2001 06:53 PM |