Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-18-2004, 10:10 PM
|
#1 |
|
Registered Member
Join Date: May 2001
Location: westerville, OH USA
Posts: 618
|
Sounds good, is it possible to use an impact gun with the air pressure turned down some to tighten the pinion/crush sleeve? I had a large breaker but it broke, plus I'm not sure I'm gonna have very much room being were working on jackstands. If it's possible to get the pinion on just right as long as I'm careful with the impact gun I'd prefer that, but I'm sure I can find a breaker bar/pipe if you think I really should. Also, any ideas on who makes the gears for Steeda? I'm probably gonna check the pinion depth being I'm not sure.
__________________
1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gears Gears Gears!!!! | COBRAon18s | Modular Madness | 20 | 05-13-2002 04:44 PM |
| AdjustTiming & 3.73 Gears install | Blue01GT | Modular Madness | 2 | 03-20-2002 02:46 PM |
| Gears Cost and Time for install | Shopkeeper | Modular Madness | 3 | 12-01-2001 05:09 PM |
| Price to install gears? | stock89 | Windsor Power | 13 | 10-29-2001 10:50 PM |
| Hard To Install 3.55 Gears??? | BowTie Eater 5 Liter | Windsor Power | 5 | 05-01-2001 04:59 PM |