Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-14-2004, 12:07 PM
|
#1 |
|
Registered Member
Join Date: Nov 2003
Location: Rockford
Posts: 596
|
Wait a minute. The intake manifold says performer 289 on it....the one bolted to the engine?????
 I used to have the same manifold on my wifes car, I don't believe Edelbrock made a perfromer 289 for a 351 W! Edelbrock makes the Performer 289 intake, Then the regular performer intake, then the Performer RPM and so on... Buddy I think you have a regular 302 base motor! If thats the case the carb you have is fine. If it is a real 351 you can still use it if it is a REAL conservitive engine. If its got some work to it, it will most likely need a 700-750 cfm carb or bigger depending on mods. See if you can list some part#'s that are on the block to verify engine. Show some pics too, if you can. Let us know. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need carb info | scheki | Blue Oval Lounge | 2 | 04-19-2004 11:26 AM |
| Carb swap info | RoushRacing6N17 | Windsor Power | 2 | 02-13-2004 01:07 PM |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| carb swap info | flyin 5.8 | Windsor Power | 1 | 08-06-2002 07:31 PM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |