Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-08-2004, 11:36 AM
|
#2 |
|
Registered Member
Join Date: Mar 2003
Location: Saint Louis, MO
Posts: 634
|
I think your very close to having it right. The best way to tell shift points is to have a dyno (to get curve info from) and then your trans type (for gear ratios) to figure best shift points for each gear.
__________________
Tom (Torque) Moss 88Gt 5spd Vert, FLowmaster Catbacks, stock cam advanced 4° @ 108.5° ICL, NMRA prepped GT40P heads 1.85/1.55 valves and 1.7 rockers, MAC P headers Jet-Hot coated, 97 Exlporer intake (ported lower), TB and injectors. 277RWHP/330RWTQ (SAE). http://www.fastlanecars.com/ |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low Power between 1500-3500 RPM | Stallion2w | Windsor Power | 9 | 01-22-2009 06:19 PM |
| At what rpm is Peak HP for a 5.0 HO in a stock '92 GT? | Fox Body | Windsor Power | 5 | 10-26-2003 10:22 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| Stock Head Porting... | Bad89stang | Windsor Power | 5 | 10-07-2001 09:20 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |