Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-19-2004, 09:29 PM
|
#4 |
|
Registered Member
Join Date: Sep 2003
Location: Mountaintop, PA
Posts: 634
|
I just completed the install of a Venom-1000. Great kit and extremly safe. Not sure if they have one for the 5.0's. The entire system is computer controlled and it probably the safest on the market. I have only run about a 40 shot as I need to still get my colder plugs installed, but it is a hoot even at that.
There is a lot of wiring to do with it as you need to tap into the O2 sensor and all the fuel injectors. If I had to do it again, I could complete the install in about 2 - 3 hours. I spread the job out over about two weeks (hour here and an hour there) as I could not decide where I wanted things placed.
__________________
"Children should not get cancer, but they do!" Help a child with cancer at www.homeoftheirown.org My Stang: 2000 Mustang GT Vert - Steeda Tri-Ax Shifter; C&L Plenum; BBK 75 mm TB; Steeda Strut Tower Supports; Black "Deep Dish" Bullet Wheels; FRPP 4.10's; Steeda Subframes; SLP Catback & SLP Catted X-Pipe; SCT 4 Position Chip with 3 custom tunes; Steeda CAI; Venom-1000 Nitrous; Roush Stage 3 Body Kit; Bullet Suspension Package (on the way) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| Going overboard building my new PC? | StangFlyer | Blue Oval Lounge | 49 | 03-07-2003 03:55 PM |
| Building first engine....help | 90lxracer | Windsor Power | 3 | 11-19-2002 08:12 AM |
| Engine Building Tips | 86GT | Windsor Power | 2 | 02-18-2001 12:23 PM |
| Building a 351w, advice | dinomite | Windsor Power | 1 | 02-06-2001 03:20 AM |