Building a 351w, advice

dinomite · 02-05-2001, 08:14 PM

I am contemplating/planning on building a 351 Windsor to put into my 90 stang. I'm in the preliminary stage, haven't bought anything yet, but looking for advice on basic stuff, like heads, cam, pistons, etc. to put on it. I'm looking for any advice on what to get, or tips/warnings for building it. Thanks!

juiceman · 02-06-2001, 03:20 AM

heres a nice little combo for ya. 351 .030 over, trw or better pistons to give 10:1 comp., zero gap rings, stock bottom end, main, rod and head studs, herbert f6j solid roller cam, roller lifters(also from herbert) , windsor sr heads with clean up, victor jr intake, 750 dp carb, roller rockers, 1 3/4 full length headers, msd dist., and all other basic stuff needed.
this setup done right will cost around 3000$ and will put you in the mid 11's. this same setup went 11.80 consistently in my car and i left the line slow.

02-05-2001, 08:14 PM	#1
dinomite The Dude Join Date: Feb 2001 Location: Arlington, VA Posts: 1,262	Building a 351w, advice I am contemplating/planning on building a 351 Windsor to put into my 90 stang. I'm in the preliminary stage, haven't bought anything yet, but looking for advice on basic stuff, like heads, cam, pistons, etc. to put on it. I'm looking for any advice on what to get, or tips/warnings for building it. Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
building a stroker need advice on solid roller or hydrallic roller cam ??	Mustangboy89	Windsor Power	4	06-06-2003 02:10 PM
I need cam advice for a 351w	82 GT	Windsor Power	6	04-15-2003 11:26 AM
does anyone have 351w heads on a 302 block need advice	93calcobra	Windsor Power	7	12-15-2002 03:21 AM
building a 408 stroker need some advice	Mustangboy89	Windsor Power	0	10-19-2001 12:14 AM
Considering the swap to a 351W - need advice	2FastLX	Windsor Power	22	06-11-2001 06:46 PM

02-06-2001, 03:20 AM	#2
juiceman Registered Member Join Date: Jan 2001 Location: ny Posts: 197	heres a nice little combo for ya. 351 .030 over, trw or better pistons to give 10:1 comp., zero gap rings, stock bottom end, main, rod and head studs, herbert f6j solid roller cam, roller lifters(also from herbert) , windsor sr heads with clean up, victor jr intake, 750 dp carb, roller rockers, 1 3/4 full length headers, msd dist., and all other basic stuff needed. this setup done right will cost around 3000$ and will put you in the mid 11's. this same setup went 11.80 consistently in my car and i left the line slow.