Building a motor for NO2

HoodStrype · 10-22-2004, 09:03 AM

|quote| Stock engine with 100 shot and slicks with run low 8's in the 1/8th just upgrade the fuel pump.
|/quote|

I had no idea a 100 shot would hit low eights... but when I think about it, it makes sense... kewl thanx!

My friend hit a 9.1 1/8 with pulleys, bypassed smog, and h-pipe... in a 93 notch so I can see it happening. Thanx again guys

~The Jester~ · 11-03-2004, 04:35 PM

Hey, just for the record, it's N2O

I had a STOCK short block out of a 1980 truck, stock forged stang pistons, Vic Jr. intake, 750 Holley, non-roller hyd. cam at about .550" lift, IRON Windsor SR. heads, running 11.71 @ 117 MPH in a quarter. With only 125 shot of giggle gas.

Biggest thing to look at is the heads, and nitrous likes lift on the cam. For what you want to do, it won't take much to build a good dependable engine, oh yeah, FAST too!

10-22-2004, 09:03 AM	#1
HoodStrype Rearview Mirror Haze Join Date: May 1999 Location: Huntsville, Alabama...a.k.a. "HuntsVegas" Posts: 387	Re: Building a motor for NO2 \|quote\| Stock engine with 100 shot and slicks with run low 8's in the 1/8th just upgrade the fuel pump. \|/quote\| I had no idea a 100 shot would hit low eights... but when I think about it, it makes sense... kewl thanx! My friend hit a 9.1 1/8 with pulleys, bypassed smog, and h-pipe... in a 93 notch so I can see it happening. Thanx again guys

11-03-2004, 04:35 PM	#2
~The Jester~ Rat Killer Join Date: Aug 2002 Location: Cold ass Ohio Posts: 1,143	Re: Building a motor for NO2 Hey, just for the record, it's N2O I had a STOCK short block out of a 1980 truck, stock forged stang pistons, Vic Jr. intake, 750 Holley, non-roller hyd. cam at about .550" lift, IRON Windsor SR. heads, running 11.71 @ 117 MPH in a quarter. With only 125 shot of giggle gas. Biggest thing to look at is the heads, and nitrous likes lift on the cam. For what you want to do, it won't take much to build a good dependable engine, oh yeah, FAST too! __________________ d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply.....

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
building a stroker need advice on solid roller or hydrallic roller cam ??	Mustangboy89	Windsor Power	4	06-06-2003 02:10 PM
Going overboard building my new PC?	StangFlyer	Blue Oval Lounge	49	03-07-2003 03:55 PM
Building first engine....help	90lxracer	Windsor Power	3	11-19-2002 08:12 AM
Engine Building Tips	86GT	Windsor Power	2	02-18-2001 12:23 PM
Building a 351w, advice	dinomite	Windsor Power	1	02-06-2001 03:20 AM