Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-27-2004, 10:51 AM
|
#7 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
Re: intake manifold gasket tips
Hey Dark,
I thought I had read about your gasket issue some time ago. At the time, I was convinced I had a bad oil ring since wet/dry comp checks were good. Tell me, did you put any silicone on the upper surface (i.e. the manifold side) of the 1262's around the front water jacket ports or front intake ports or just the gasket to head side? I have read where guys have done it both ways, but I don't want to screw up the gasket by putting RTV on the upper surface if it is not needed or will screw up the seal. Thanks again.
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra intake manifold | stanger9219 | Windsor Power | 2 | 09-12-2003 07:09 AM |
| 302 Intake Manifold | btacarlton | Windsor Power | 2 | 08-31-2003 06:08 PM |
| Intake gasket woes.....any suggestions? | jim_howard_pdx | Classic Mustangs | 12 | 04-28-2002 10:19 PM |
| (Where can I/What is) a good intake manifold? | Sonics2042 | Windsor Power | 11 | 12-27-2001 05:48 PM |
| gasket matching intake ports | matt cook | Windsor Power | 3 | 12-07-2001 04:44 PM |