Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-09-2005, 06:28 PM
|
#2 |
|
Registered Member
Join Date: Jan 2001
Location: Moline Il
Posts: 901
|
Re: Got my driveshaft loop today...question
6 inches past the tailhousing and 'just behind the front u-joint' should be 1 in the same. Or thereabouts. Give yourself another inch. If you get the loop too close, it will be a pita to get the trans in. In my buddies 88 which was set up for a glide, we have to pick the back of the trans up and put it through the loop, then push the trans forward in to the bellhousing.
Andy
__________________
88 coupe 91 LX NMRA Pure Street 5120 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| driveshaft safety loop install? | Simi Stang | Windsor Power | 16 | 02-12-2003 07:45 PM |
| DriveShaft Loop Install...Help!!!! | Stang Runner | Windsor Power | 6 | 05-06-2002 06:04 PM |
| Going To Make A Driveshaft Safty Loop... Need Measurements Please | BowTie Eater 5 Liter | Windsor Power | 2 | 01-29-2002 11:08 AM |
| HELP Quick w/ HPM Driveshaft Loop Install ??? | jmeiers | Modular Madness | 1 | 06-30-2000 06:16 PM |
| Anybody install a driveshaft loop on a early Mustang! | 67enthusiast | Classic Mustangs | 1 | 03-18-2000 11:33 AM |