Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-13-2005, 07:10 PM
|
#3 |
|
Registered Member
Join Date: Jun 2002
Location: manassas, va
Posts: 186
|
Re: Honing Mistake?
Been there, done that. His reply, "Welcome to the world of high performance" NO warranty on high perf motors, everyone knows that. I will just have to be sure to keep it under 6200 rpm now.. it will go to 7000 pullin hard on N2O. Probably the reason why it spun
__________________
1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tremec TKO II w/ 0.82 OD and 3.73 rear end... Mistake? | Treachery | Windsor Power | 4 | 11-15-2004 08:23 PM |
| Oil anyone?? Made a little mistake... | msunickb | Windsor Power | 6 | 04-20-2003 11:46 PM |
| Stupid Mistake, how do I fix it? | AdamM | Windsor Power | 1 | 07-14-2002 01:58 PM |
| Anyone else make the mistake of auto-xing an AOD? | LOCASH | Corner Carvers Delight | 3 | 04-05-2002 04:22 PM |
| mass air mistake | Paul Grande | Modular Madness | 4 | 01-30-2002 02:23 AM |