Crankshaft Pulley(Vibration Damper) Removal

[ByrdPE]

Originally posted by PKRWUD:
How many times do I have to post this before you guys remember?

Mount a socket with a short extension on a breaker bar, and set it on the crank bolt. Rest the breaker bar handle on the ground, on the drivers side of center. Unplug the coil, and bump the starter with the key. Works PERFECT EVERY SINGLE TIME! Don't go anywhere near it with a hammer. Trust me.

Take care,
-Chris

Thanks for posting it again Chris.
I have never heard of it being done this way.




------------------
FMS 373,Mac U/D Pullies,B&M shift kit,B&M Trans cooler,
KYB's,FMS 65mm T/B,Moroso cold air kit,75mm Bullet,BBK sub frame connectors,Power-slotted rotors w/performance friction pads
PST performance sway-bar kit,3G alternator,Maximum Motorsports Strut tower brace,Maximum Motorsports G-Load brace
Maximum Motorsports lower control arms,Autometer,oil,H2O,
volt MSD6AL,MSD Blaster coil,'Tiny Avenger'intake pipe