Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-19-2001, 12:37 AM
|
#2 |
|
Registered Member
Join Date: Nov 2000
Posts: 290
|
I buy most of my stuff from Mustangs Unlimited and National Parts Depot. Been real impressed with the sheet metal I've bought in terms of the quage and quality, however, rarely have I bought any reproduction piece that fits as good as the original. Have sent one decklid back and had to do some fine tuning (minor bending) on the front and rear valances I've ordered. I'd also like to know who makes, or sells, the best reproduction parts.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
| Sheet metal | TIP64 | Classic Mustangs | 6 | 10-24-2001 01:40 PM |
| Found pieces of metal in the throttle body and IAC valve...Please Help! | Ford Vader | Windsor Power | 1 | 07-16-2001 03:35 PM |