Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-15-2001, 04:24 PM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Georgia
Posts: 84
|
Ford only made the Boss 351 in 71, if the motor in your car is not orginal there are a few ways to tell if it is a Boss. The Boss 351's had aluminum intake manifolds, dual vaccum advance on the distributor, dome top pistons, and beefier connecting rods. I think the Boss motors were the only ones to use a square carb mounting flange the rest used a spread bore design. Ford also used 4-bolt main blocks on the 351CJ during these years so you could have one of those.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boss Mustang | stacy's stang | Modular Madness | 7 | 03-17-2004 06:27 AM |
| Boss mustang | TRipSOber | Modular Madness | 6 | 05-05-2003 08:37 AM |
| Boss Pistons For 347 Stroker | Ford_Racer_1 | Windsor Power | 3 | 09-09-2002 05:39 PM |
| Overated BOSS Mustangs? | Sac68 | Blue Oval Lounge | 43 | 03-01-2001 05:20 PM |
| need Boss 302 info | SteveOhio | Classic Mustangs | 2 | 05-26-2000 06:34 PM |