Why is my car a fat pile of $hit?

fastang · 09-26-2001, 11:40 PM

Ok, plugs are gapped at 54 and they are the right length but I havent taken them back out and looked at them yet. I probably will tommorow.

AJ said the the correct pushrod length was 6.7. I am using 6.8's The instructions with the heads said to use 675's but I couldnt find any. My rockers are adjustable so I used them to make up the slack. Maybe I should take full advantage of the longer pushrods and re-adjust my rockers?

I am installing a new TPS tommorow and buming my timing up to around 16-17. Then Im going to raise the fuel pressure a tad an see how she runs. I will let you guys know how it turns out.

------------------
95GT, TFS T.W. heads, Holley Intake, B303 cam, FRPP 30lb injectors, Scorpion 1.6 rollers, 65mm TB, 73mm MAF, BBK Longtubes, Flowmaster cat back, March Pulleys, MSD coil, 9mm wires, Tremec 3550 trans, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors. 190lph pump, BBK adj FPR.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
AOD $HIT/ OR T5 SWAP?(PLEASE HELP)	joey50gt	Windsor Power	5	10-04-2009 02:29 PM
WHOLLY $HIT!!......FLAMES!!	fastang	Stang Stories	13	11-03-2001 06:02 PM
Crazy $hit here in NY	bada$$lx	Windsor Power	5	09-12-2001 04:39 PM
Got my $hit kicked	smithbling	Stang Stories	2	05-29-2001 06:05 PM

09-26-2001, 11:40 PM	#1
fastang Registered Member Join Date: Aug 2000 Location: santa ana ca Posts: 1,349	Ok, plugs are gapped at 54 and they are the right length but I havent taken them back out and looked at them yet. I probably will tommorow. AJ said the the correct pushrod length was 6.7. I am using 6.8's The instructions with the heads said to use 675's but I couldnt find any. My rockers are adjustable so I used them to make up the slack. Maybe I should take full advantage of the longer pushrods and re-adjust my rockers? I am installing a new TPS tommorow and buming my timing up to around 16-17. Then Im going to raise the fuel pressure a tad an see how she runs. I will let you guys know how it turns out. ------------------ 95GT, TFS T.W. heads, Holley Intake, B303 cam, FRPP 30lb injectors, Scorpion 1.6 rollers, 65mm TB, 73mm MAF, BBK Longtubes, Flowmaster cat back, March Pulleys, MSD coil, 9mm wires, Tremec 3550 trans, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors. 190lph pump, BBK adj FPR.