Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-18-2001, 12:43 PM
|
#7 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
That is what we did with my 88gt is try to make it look stock and make people wonder how I was pulling off 13.4 to 13.5 ET's on 225/60/15's only running a 2.0 to a 2.2 60ft.
We grinded the weld down and polished the intake so you could not tell it had been cut and re-welded; you could tell if you really looked hard and you knew what you were looking at but it looked great. I started off doing it because I could not afford much at the time but when I started winning races and I told them it was stock, seeing the look on peoples faces when I popped the hood; well I hade to do more. We opened the the mouth of the uper intake so much that one of the center bolt holes hade to be welded up. ------------------ James Cox nochevy@hotmail.com 1991 Mustang LX 12.565 @109.38mph 1.764 60ft |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.6L Intake spacer!!!! | skz4u | Modular Madness | 18 | 01-27-2003 11:11 PM |
| Porting lower intake?? Velocity vs. Flow | Dark_5.0 | Windsor Power | 1 | 11-11-2002 02:42 AM |
| gasket matching intake ports | matt cook | Windsor Power | 3 | 12-07-2001 04:44 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |