Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-05-2001, 01:28 PM
|
#2 |
|
Registered Member
Join Date: Oct 2000
Location: Atlanta,GA,USA
Posts: 278
|
I think they actually use glow plugs from a deisel engine in the tailpipes for that. I'm not sure cause I've never done it. You probably need to run a very rich mixture or have a cam with lots of overlap. The overlap would allow some unburnt air and fuel to pass right through the chamber to the exhaust at low rpm's.
------------------ 67 Fastback - Arctic White Pearl paint 351W ,Trick Flow Aluminum Heads, Edelbrock TorkerII, Comp. Cam, Performance Automatic C-4 Trans, 3.55 gears, Front Disc Brakes, 1-1/8" Fr. 3/4" rear sway bars.  |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Trick Flow Manifold Install | squid | Windsor Power | 1 | 11-09-2002 06:24 PM |
| A Really sweet trick for mustangs 99 and up | MBC50403 | Small Ponies | 0 | 08-17-2001 01:02 PM |
| Trick Flow Specialties good guys! | 8850 | Windsor Power | 1 | 03-24-2001 11:33 AM |
| Trick Flow "R" Intake on a stock 88 5.0??? | BowTie Eater 5 Liter | Windsor Power | 3 | 01-15-2001 09:44 AM |