Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-04-2001, 11:38 PM
|
#4 |
|
Registered Member
Join Date: Jun 1999
Location: Greenville, NC, USA
Posts: 34
|
The brothers performance web site has a tech note under roller rockers heading that says that you can usually run up to .545" without problems but there are always the variables like gasket thickness and whether or not the heads or deck have been milled. The year that this wouldn't work on would be the 86 due to the flat top pistons.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| South Side Machines Lift Bars..... | cucho | Windsor Power | 7 | 01-29-2004 10:51 PM |
| stock gt40p lift and high lift cams | homeroV8 | Windsor Power | 0 | 11-28-2002 10:34 AM |
| cam lift question | redsn95vert | Windsor Power | 1 | 04-28-2001 09:58 PM |
| SSM lift or Lakewood lift bars | ponypower | Windsor Power | 10 | 02-11-2001 07:26 AM |