Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-14-2001, 05:08 PM
|
#4 |
|
Registered Member
Join Date: Dec 1999
Location: Warrington, PA
Posts: 694
|
Don't waste the $ on the headers. It takes too much time and work and/or costs too much in labor to justify spending the $ for the small gains. The stock heads don't flow well enough to utilize the headers.
A high Flow H-pipe will be the best bang for buck. That should add anywhere from 8-14hp. A good set of mufflers, or a full cat-back may help to free up another 2-4hp. ------------------ 1997 Thunderbird 4.6L: Dynomax cat-back, MN-12 perf. offroad downtubes and Y-pipe w/ Magnaflow resonator, 80mm MAF with cone filter, B&M trans cooler, Inject-Tech chip, KVR front brake upgrade. 15.2 @ 91 before exhaust. Not bad for a 3800lb auto 4.6L No Longer own: 91 LX 5.0L 5 spd |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Full length or shorties? | Nicodemus | Small Ponies | 5 | 08-04-2002 10:55 AM |
| MM subframes....standard or full length? | DemonGT | Windsor Power | 3 | 04-22-2002 09:38 AM |
| full leanght header ground clearance | bosco | Windsor Power | 3 | 01-28-2002 03:03 PM |
| Too Low Exhuast! | MidNiteBlu 5.0 | Windsor Power | 6 | 10-05-2001 05:59 PM |
| full length or standard length subframe connectors? | 84stangLX | Windsor Power | 4 | 04-23-2001 03:48 PM |