Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2001, 03:51 PM
|
#2 |
|
Registered Member
Join Date: Apr 1999
Location: Overland Park, KS, USA
Posts: 1,631
|
You can use a voltometer....but I think they may have to be hooked up to a car for that (or at least a power source). You could always send them off to have them flow-checked and tested.
------------------ 1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
| differences in injectors? | '89GTStang | Windsor Power | 9 | 06-06-2003 02:39 AM |
| MAF and FPR independent from injectors? | Nixon1 | Windsor Power | 4 | 03-01-2003 02:00 AM |
| Which Injectors Can I Use? | SPower6 | Windsor Power | 11 | 01-10-2002 04:46 PM |
| will Chevy injectors work in a Ford | tireburner163 | Windsor Power | 4 | 06-16-2001 07:16 PM |