Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-06-2002, 10:48 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
Long tube installation?
I was thinking of getting a set of long tube headers to replace the stock ones i have, but I'm not to technically adapt yet. What kind of mods would i have to make to my existing h-pipe bolted up to stock headers for the long tubes to fit? And is it really worth the effort? I'm planning on putting on the mods listed below and when im done with them twisted wedge heads and a new cam...
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1 3/4 long tube header install. | Dark_5.0 | Windsor Power | 1 | 08-05-2004 01:51 PM |
| Headers - Shorties or Long Tube? | SleeperGT | Modular Madness | 6 | 03-07-2003 11:19 AM |
| Whats the going price for long tube header installation? | Dark_5.0 | Modular Madness | 3 | 09-19-2002 03:29 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |
| 95 Cobra - Long Tube Headers question? | Skyman | Windsor Power | 1 | 02-15-2001 10:25 PM |