Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-01-2002, 11:45 AM
|
#1 |
|
Registered Member
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
|
B303 cam w/ speed density will it work?
I am buying a gt40 motor with a B303 cam my car is a 87 with sd and i really dont care to change it over to mass air, due to the cost and time but mostly the cost i am going to have no money left in the bank =). I heard that you can get away with the e303 w/sd with some time and a fuel pressure regulator, the motor is suppose to arrive in two weeks. Any suggestions on how to stay sd and run the cam.....
thanks for ur time guys -raini
__________________
87-ford-mustang-SOLD! mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again SOME ADVICE Don't do burn outs in reverse it is very expensive New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system Fastest time to date: 12.8@113 Last edited by drtbiker; 08-01-2002 at 01:13 PM.. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speed Density Questions knowledgable tuners needed | William Bowers | Windsor Power | 8 | 12-10-2002 11:31 PM |
| Speed Density Cobra? | UglyFast88 | Windsor Power | 6 | 12-10-2002 11:25 PM |
| Bigger injecters and Vortech A-trim with speed density. | Dark_5.0 | Windsor Power | 4 | 12-06-2002 07:41 PM |
| Hey (speed density) people........is this guy right or what?? | Dark_5.0 | Windsor Power | 13 | 12-04-2001 01:08 PM |
| 86 speed density | kystang86 | Windsor Power | 4 | 01-05-2001 12:18 AM |