

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
View Poll Results: Which Supercharger for the Saleen S281? | |||
Paxton Novi 1000 |
![]() ![]() ![]() ![]() |
2 | 7.41% |
Paxton Novi 2000 |
![]() ![]() ![]() ![]() |
8 | 29.63% |
Vortech S-Trim |
![]() ![]() ![]() ![]() |
4 | 14.81% |
Procharger |
![]() ![]() ![]() ![]() |
10 | 37.04% |
Powerdyne |
![]() ![]() ![]() ![]() |
0 | 0% |
Vortech T-Trim |
![]() ![]() ![]() ![]() |
1 | 3.70% |
Eaton/Saleen Roots blower |
![]() ![]() ![]() ![]() |
2 | 7.41% |
Voters: 27. This poll is closed |
|
Thread Tools | Rate Thread | Display Modes |
![]() |
#30 |
Registered Member
Join Date: Aug 2001
Location: Long Island, NY
Posts: 71
|
![]() The reason I brought up the turbo is because on the 4.6, it makes a ton of power. I had a V2 S-trim and both @ 12 psi wouldn't be a race. I made more with less than 6 psi than any centrifugal blower would have made at 8 psi & some @ 12 psi. Full boost comes in at about 3,000 rpms sooner and the torque amount & curve is tons better. Sure a P-1SC was good for 800 hp, but you will be spinning the crap out of it and dealing with belt slip and it will have a short life.
The TDC kit is well thoughtout and is made with the best parts available. I haven't run into any of the problems mentioned above with the turbo system after 4 months and much track use. I tossed my blower because everyone with a 4.6 has one and I wasn't getting anywhere fast. With the turbo system, I blew past all of my friends with blowers and stock engines. If you are dead set on getting a blower, I would get a D-1SC because you will have much more room to grow. I don't mind dealing with the any small problems that might occur because the benefits have been unreal. The car has been faster than most people would believe and is dead silent at idle and cruising.
__________________
99 Silver GT Auto DTA Built Engine w/P&P heads, TDC Turbo (T-76), Built 4R70W, PI Multi-Disc 3200 T/C, Eaton 31 Spline Carrier, Strange 31 Spline Axles, Aeromotive 1000 HP fuel system, 66lb injectors, MSD DIS4, Accel DFI Gen VII & Mac 3" cat-back. Built by Jade Performance Best on Nitto D/Rs 11.698 @ 120.898 @ 12 psi (built block) Best on Slicks 10.922 @ 122.95 (stock longblock) |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Roots supercharger (like Kenne Bell)....who offers them? | 84LX89GT | Windsor Power | 10 | 08-10-2006 06:23 PM |
96 Cobra Supercharger questions | mosibobo | Modular Madness | 8 | 08-09-2006 01:50 PM |
FMU and Supercharger Pulley Question | NitroNixon | Windsor Power | 3 | 05-14-2003 08:06 PM |
Want Supercharger But have 9.8:1 comp. is this trouble? | NewAge 5.0 | Windsor Power | 4 | 12-18-2002 08:50 AM |
Paxton Supercharger Guys LOOK | 89 Cobra LX | Windsor Power | 1 | 06-11-2002 03:10 PM |