Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-06-2001, 12:36 PM
|
#8 |
|
Registered Member
Join Date: Feb 1999
Location: Kennesaw, Georgia, USA
Posts: 252
|
OK, so I've found a few sources with some info on rear ends. After going over a couple of them, I've noticed they mentioned the use of a press. Is this absolutely necessary, or are there any tips or tricks to get around needing one? Thanks again guys.
__________________
MAC equal length headers, MAC Off-Road H-Pipe, Flowmaster mufflers, 373's, underdrive pulleys, 76mm MAF, 65mm TB, TFS Track Heat Intake(ported & gasket matched), Edelbrock 6037 heads (ported, polished, 3 angle valve-job 255CFM @.500), 1.6 FMS RR's, Wolverine 1087 Cam, 30lb injectors, MSD 6AL, Subframe connectors, Griggs Adustable Lower Control Arms, Lakewood 50/50 shocks, SSM Upper Control Arms... and 8lbs of Procharged boost |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new rear end | fordkid68 | Classic Mustangs | 18 | 11-24-2009 08:05 PM |
| want rear disk without changing overall length of rear....please help!!! | dragstang86 | Windsor Power | 1 | 07-31-2003 06:32 PM |
| cobra rear questions | dragstang86 | Windsor Power | 3 | 07-02-2003 06:56 PM |
| installing cobra rear in my LX...picked up a totaled 93 limited edition | dragstang86 | Windsor Power | 1 | 05-26-2003 11:23 AM |
| Recall 01S15 Rear Knuckle replacement | folthoff | Special Production | 0 | 05-02-2001 08:28 AM |