Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-07-2001, 01:15 PM
|
#3 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
It's basically a vent to let out the air pressure in the crankcase.
It is on the very back in the center of the lower intake manifold (kinda hard to reach). It has a fairly large vacuum line coming off of it and that leads to the drivers side of the upper intake. Yes you should replace it. It's an important piece of your normal tuneup. Don't get a autozone or other parts store PCV valve because they dont fit right and sometimes can cause a little oil to come out. Get one from a local ford dealer's parts dept. They're not expensive. But they can be hard to find/reach if you've never seen exactly where its at before. Hope this helps
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve tap!! | SmokinStangGT | Windsor Power | 1 | 07-31-2003 03:42 AM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |