Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-09-2001, 01:43 PM
|
#4 |
|
Registered Member
Join Date: Mar 2000
Location: Springfield, Ma, usa
Posts: 706
|
since you already have a cam you are probaly going with 1.6 ratio. all i had to do with 1.6's was remove the baffle on the passengers side valve cover. i think if you were to run 1.7 ratio your would have to grind the first 3 structural supports on each vavle cover.
__________________
NewEngland Auto www.baystategearheads.com -91 Mustang Coupe, ex 4cyl (sold) -99 F150, 3" lift, 35" Procomps, Magnaflow exhaust |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| 4.6L Intake spacer!!!! | skz4u | Modular Madness | 18 | 01-27-2003 11:11 PM |
| Porting lower intake?? Velocity vs. Flow | Dark_5.0 | Windsor Power | 1 | 11-11-2002 02:42 AM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| cobra intake spacer? | DemonGT | Windsor Power | 11 | 05-05-2001 01:52 AM |