

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Dec 2001
Location: NC
Posts: 29
|
![]() FWIW, it ounds like you out drove this guy for the kill. Congrats. Im sure you embarrassed him pretty good.
As for a SC'd LT1 trapping 105 mph? Sounds like a tuning or a traction issue. I trap 104mph stock in my 97 SS. Something is off there. Not doubting you, I wasnt there. A SC'd LT1 should trap around 115mph. The stock compression ratio on theese motors is 10.5:1, so they dont respond well if they arent tuned correctly. There is alot to it. Sounds like this guy has a "untouchable attitudes". Doesnt do the fbody name any good. BTW, I havent seen a SC'd run in person, only on mpegs or video. I have seen 3 LS1's run. I saw a guy run a 12.2 spinning though 330' and almost into the eighth before pedalling and hooking. For stock LT1 dyno numbers, most Z/28's put down anywhere from 250 rwhp up to 265. Once again, in my SS I laid down 282 rwhp stock. Thats not bad for an LT1. A SC'd should toss down in the upper 300's (close to 385-400) with a bigger fuel pump and ignition. Be happy you can drive. It will get you many surprise victories. Keep the mods comin to make sure you can back it up too. ![]()
__________________
1997 Hendrick Motorsports Edition Camaro SS 1969 Camaro Z/28 1993 LX 5.0 Photopoint sucks! |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
rematch results with the audi s4 and 99 ls1 trans am are in! | 46stang | Stang Stories | 5 | 11-23-2004 02:00 PM |
Results of my race with M3 | StoplightWarrior | Stang Stories | 22 | 02-13-2002 12:33 PM |
1996 Cobra vs 2001 Trans Am | Milktasd | Stang Stories | 2 | 01-22-2002 09:27 PM |
Racing a SuperCharged Trans Am this weekend!!! | CobraConv99 | Stang Stories | 20 | 12-01-2001 05:58 PM |
Results of the Race! | Mean50 | Stang Stories | 2 | 04-06-2001 07:12 PM |