Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-15-2001, 04:44 PM
|
#11 |
|
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
I have gained about 60rwhp from the unported TFS head/Holley intake swap. The TFS heads will outflow the AFR 165's mostly because the AFR 165's have smaller valves. The AFR 185's are probably the best head around right now but you cant use them on a stock shortblock without notching your stock pistons(which is risky) or buing a new set of dished pistons.
The TFS heads and the AFR 185's both have 202 intake valves but the Trick flows are cantered at an angle so the large valves will clear the pistons while the AFR's will not. However ALL AFR heads come cnc ported too while the TFS heads are not.......but then again the TFS heads are about 400 bucks cheaper and can be CNC ported for a few extra bucks too.
__________________
98 GT manual trans, Magna Flow exh. old car: 95GT, TFS T.W. heads, Holley Intake, B303 cam, FRPP 30lb injectors, Scorpion 1.6 rollers, 65mm TB, 73mm MAF, BBK Longtubes, Flowmaster cat back, March Pulleys, MSD coil, 9mm wires, Tremec 3550 trans, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors. 190lph pump, BBK adj FPR. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help I need heads!! | SmokinStangGT | Windsor Power | 18 | 05-04-2003 10:05 PM |
| New FRP Heads for 96 - 98 4.6 | surfbeast | Modular Madness | 9 | 11-21-2002 07:02 PM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |