Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-19-2001, 06:02 PM
|
#7 |
|
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
I have one question? Are you planning on building your own engine or having someone do it?
If you are planning on doing it yourself. Use a 400 crank. turn the mains down to fit the 351 block (not sure the dia.). Buy a good set ( I prefer Childs and Albert) of rods 6.25 inches long. Bore a block .030 over, and put good forged pistons (Ross, Kieth Black) or etc in it. You have a 408 stroker then. High revin motor that with a good set of heads and intake combo should have no problem making that 500 number. I would use the Trick Flow R heads. As far as intake goes, I stay away from efi cars so I can't suggest anything there.
__________________
1990 GT, 347, TFS TW Heads, TFS Cam, TFS Track heat, Twin turbos, FMIC, T5. Built Ford Tough Moderator |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stroker Questions | Falcons Talon | Windsor Power | 2 | 09-17-2004 08:13 AM |
| 408 stroker questions... fuel injection vs carb | XR1stang | Windsor Power | 4 | 08-23-2004 08:25 PM |
| 347 stroker questions | bottlebaby91 | Windsor Power | 23 | 11-23-2003 03:03 PM |
| stroker questions | Ieatcamaros | Windsor Power | 14 | 09-30-2003 05:21 PM |
| Stroker questions. | ~The Jester~ | Windsor Power | 11 | 02-28-2003 03:45 PM |