

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Feb 2001
Location: Edmond, OK
Posts: 180
|
![]() What's your timing set too?
Or did you not have to pull or loosen the distributor when you swapped the intake? What about the gaskets for the intake? Will they go on either way or do they only fit one way? Did you check to make sure that all the cooling holes were open and not blocked off by the gasket? Are you using a 50/50 mix of water/antifreeze? The thermostat is directional. When you put it in, did you face it the right way? It has an arrow on it. [This message has been edited by rtz (edited 03-11-2001).] |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
Horsepower Loss / Cooling Problem | A Wild Neg | Windsor Power | 4 | 04-18-2001 11:55 AM |
Cooling Problem - I think | sfedenia | Windsor Power | 4 | 04-12-2001 12:33 PM |
still isnt fixed, cooling problem part 3 | fiveohpatrol | Windsor Power | 2 | 03-26-2001 10:14 AM |
Headlight Switch Problem : Part 2 | Gautam | Windsor Power | 2 | 01-22-2001 11:49 PM |