Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-29-2001, 12:34 PM
|
#1 |
|
Registered Member
Join Date: Oct 2000
Location: Maryland
Posts: 71
|
Actually, with 1.7 rockers on the E303 cam, that will give you a .529 lift. Heres how you figure it out. .498 ( stock E cam lift ) x 1.7 ( ratio you'll be using for the cam )/ 1.6( the ratio your supossed to use )= .529
Now if you were to use the 1.72 rockers, that would give you the .535 lift. If thats the case, you should check p/v clearance just to be safe. I think the E303 cam is a good n/a cam. What kind of idle problems are you having with it? I know my E cam liked to have an idle right around 900rpms. good luck Dan |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What head gaskets and intake gaskets?? | dragstang86 | Windsor Power | 4 | 12-20-2002 04:20 AM |
| blown head gaskets!!!! (read) | 11secondGT | Windsor Power | 9 | 08-27-2002 08:54 PM |
| Re-using head gaskets? | Thad | Windsor Power | 11 | 08-07-2002 10:49 AM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |