Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-01-2002, 01:50 PM
|
#2 |
|
Registered Member
Join Date: Mar 1999
Location: Arcadia, CA, USA
Posts: 731
|
Just my two cents. Based on my friend's experience with the Seniors, they'll wind to 6000 without a problem. It's kinda difficult to determine the exact powerband without knowing the induction system, exhaust, and cam.
Nice heads. You've got a lot of material to port, if you choose. Extreme porting on my friend's heads yielded 270 CFM Intake, 180 exhaust at 0.500 lift and 28 inches of H2O. Despite the weight, cast iron does have a few advantages over aluminum.
__________________
Russ L '91 LX - 331 w/ Procharger '03 Cobra Convertible - Pullied '94 Lightning '65 Mustang Coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| 351 head questions on my 5.0 | vetteeatr | Windsor Power | 0 | 08-28-2001 04:03 PM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |