Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-01-2002, 03:17 PM
|
#1 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
Quite frankly, I think you're going to lose a TON of low end with those heads. Flow rate is very linear, and huge runners make for **** port velocity. That and they don't flow as well as many aluminum heads on the market. That exhaust flow is shitty if those numbers are right.
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block and head machining questions | bmxmon | Windsor Power | 6 | 09-26-2004 02:21 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| 351 head questions on my 5.0 | vetteeatr | Windsor Power | 0 | 08-28-2001 04:03 PM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |