Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-15-2002, 08:04 PM
|
#8 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
My '66 tests at 195 psi or there abouts with a Comp Cams 268 HE. that's 218/218 at .050" lift. It was set up with a 9.5/1 CR. I run a total 45 deg. of advance, all in by 3000.
The reason it needs that much is because I'm using 351W heads which are not really very efficient. When I get my new TFTW heads in (as I type), I'll start with 36 geg. total advance. So far have had no detonation problems using 92 octane pump gas. Crossing my fingers with these new heads. Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| increasing compression ratio | 84LX89GT | Windsor Power | 6 | 11-14-2003 10:40 AM |
| #1 @ TDC on compression stroke? | 302 LX Eric | Windsor Power | 1 | 09-23-2003 04:19 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Need help!...no compression in 6 and 7!! | bobtodd | Windsor Power | 6 | 09-13-2002 03:09 PM |
| high or low compression engines | Mustangboy89 | Windsor Power | 6 | 01-26-2001 03:04 PM |