Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2001, 10:27 AM
|
#3 |
|
Registered Member
Join Date: Sep 2000
Location: Fresno,CA. USA
Posts: 384
|
that chip is the SPOUT connector...if you don't take it out it won't adjust properly. Also careful not to lose it. I't easy to forget you took it out, then never put it back in.
Start the car, take out the SPOUT, adjust your timing(use 12-14) experiment at the track for anything else, and always use premium) then put the SPOUT back in.....and your ready to rock. If you forget to put in in...you will run about 5 cars slower than b4.No spark curve at all. [/B][/QUOTE] ------------------ 4.10's,long tubes & 75 shot...Goes 12.50's Check it out at http://www.burnouts.webprovider.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |
| nos & timing controller | todd5litre | Windsor Power | 5 | 01-09-2001 08:24 PM |