Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
| View Poll Results: Do we need a new Power Adder forum? | |||
| Yes! There's enough power adder question it would be heavily used and lighten the load in main tech forums too. |
   
|
27 | 50.00% |
| No. I don't think it would be heavily used right now and the traffic isn't too bad still in the main tech forums. |
  
|
18 | 33.33% |
| I'm undecided. Hard to tell yet, so give it some more time and we'll visit this question again later. |
  
|
9 | 16.67% |
| Voters: 54. This poll is closed | |||
|
|
Thread Tools | Rate Thread | Display Modes |
01-17-2002, 10:35 AM
|
#16 |
|
Registered Member
Join Date: Jun 1999
Location: Walker, MI, USA
Posts: 1,202
|
Uint does have a good Point about the Winsor Guys and the Mod Guys it could be a bit confusing at times But I would be Up for a test Run of it I will Post in It as much as I could. I realy dont like it when there are about 3 of more Place I might make my post and If I did not know what one would be the best place to post it I dont think the Windsor Power forum as to much Traffic to realy need a new One.
__________________
Engine: steel mounts, Under drive pulleys, K&N, GT-40 Intake ported Lower, No power steering, No A/C, Mac cold intake, 65MM TB, 255 Fuel pump, 24's, AFR 165 58cc, Rocker Arms 1.7with the stock Cam, 1 5/8 short headers, offRoad X-pipe Drive Train: 3.55, T-5 with a Pro 5.0 shifter 12.656@107.71MPH See It at www.T-racing.com/mustang.htm |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welcome to our new Power Adder Forum | StangFlyer | Power Adders | 1 | 04-21-2003 03:48 PM |
| Power adder fourm / ATTN: Dan | Five0 | Blue Oval Lounge | 6 | 07-17-2002 05:32 PM |
| Power adder fourm ATTN: Dan | Five0 | Blue Oval Lounge | 0 | 07-15-2002 10:15 PM |
| Best Power Adder? | SCOTTLT79 | Windsor Power | 4 | 07-06-2001 02:13 AM |