Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2001, 09:00 PM
|
#8 |
|
Registered Member
Join Date: Feb 1999
Location: Caracas, Venezuela
Posts: 81
|
I have steeda rounds and the seat brackets are great, my car has a tiny crack on the floor, and when onstalled it didn't grew any more.
Square to weld what? I welded the tube end brackets to the frame, and really think that it's enough. lito ------------------ 92GT,SOLO RACER, COBRA BRAKES, R1 TIRES, GT40, GT40X HEADS 58CC, 24LBS, 70MM/65MM, E303, 4.10, MANY ROAD RACE MODS, CORVETTE, CAMARO, RX7 AND SUPRA SOLO EVENT EATER www.killersracing.com www.clubcopa.com  |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bullit Intake Aftercooled Discharge Tube | SlwGT | Modular Madness | 0 | 06-10-2002 08:27 PM |
| CAI with C&L inlet tube? | chris91LX | Windsor Power | 11 | 04-16-2002 08:20 PM |
| I want to remove my EGR tube | moponys | Windsor Power | 0 | 12-04-2001 10:54 AM |
| Welding in subframes and removing front sway bar . What should I run?? | Dark_5.0 | Windsor Power | 4 | 10-27-2001 03:06 AM |
| Subframes...Round or Square? | jrfaraci | Windsor Power | 13 | 07-13-2001 07:37 PM |