Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2002, 10:43 PM
|
#8 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
Your oil pressure is not doing what it's supposed to. If you are certain your measurements are correct, then the only possibility is the oil pump bypass valve is stuck closed, or partially closed. Driving with it like this can be dangerous, and is not advised. Possible results include a ruptured oil filter, popped out oil galley plugs, a damaged pump and bearings. More than likely, pieces from your valve stem seals or RTV that has come loose has jammed the pressure relief valve.
Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much money to build a high 10 sec Honda (using V-tec engine)? | Fox Body | Windsor Power | 27 | 12-11-2002 08:22 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Pushrod Vs. Modular | chetwindell | Windsor Power | 14 | 06-30-2002 05:56 PM |
| 4.6 vs 5.0 | CactusHugger11 | Modular Madness | 11 | 05-01-2002 01:32 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |