No Computer Codes = Bad Parts? (long)

slo95 · 04-03-2001, 02:32 PM

Thanks, the Timing is at 10*, set at Ford after the new converter install. Still has the nice bright yellow paint on the tick marks so it is EASY to read. I verified w/o spout, and checked for advance with spout. It is okay.
More Info?!, hmmm, didn't really want to BORE anyone more than that first post, but there is really nothing else I can think of, except for the TPS setting. HERE IT IS, also a diff post " I just checked my TPS voltage and resistance, and I think it is arse-backwards...just sitting there, harness unplugged, the resistance on the two lower pins is high, and goes down smoothly as the TB plate opens. BUT the voltage on those pins, KOEO is 4.36vdc closed, and WOT it is at like .48 vdc . can this be right? I always read that it should be around .98 KOEO, and in the 4v at WOT"
I have to get a vacuum and fuel pressure gauge to check those related things, I was kinda holding off to see if a solution would be found BEFORE I dump a hundred bucks on test equipment to then spend more for the fix.

[This message has been edited by slo95 (edited 04-03-2001).]

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Which is your favorite general auto parts store?	Fox Body	Blue Oval Lounge	28	12-07-2017 11:18 AM
Super rich condition... Codes inside	Bad89stang	Windsor Power	8	08-22-2003 03:35 PM
supercharger kit for 03 gt	03GT	Modular Madness	9	05-29-2003 06:38 PM
Computer Question	MustangGT1990	Windsor Power	7	11-30-2002 11:52 PM
Issue with the Parts Girl	302 LX Eric	Blue Oval Lounge	22	06-30-2002 06:58 PM

04-03-2001, 02:32 PM	#5
slo95 Registered Member Join Date: Dec 2000 Posts: 168	Thanks, the Timing is at 10*, set at Ford after the new converter install. Still has the nice bright yellow paint on the tick marks so it is EASY to read. I verified w/o spout, and checked for advance with spout. It is okay. More Info?!, hmmm, didn't really want to BORE anyone more than that first post, but there is really nothing else I can think of, except for the TPS setting. HERE IT IS, also a diff post " I just checked my TPS voltage and resistance, and I think it is arse-backwards...just sitting there, harness unplugged, the resistance on the two lower pins is high, and goes down smoothly as the TB plate opens. BUT the voltage on those pins, KOEO is 4.36vdc closed, and WOT it is at like .48 vdc . can this be right? I always read that it should be around .98 KOEO, and in the 4v at WOT" I have to get a vacuum and fuel pressure gauge to check those related things, I was kinda holding off to see if a solution would be found BEFORE I dump a hundred bucks on test equipment to then spend more for the fix. [This message has been edited by slo95 (edited 04-03-2001).]