Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-24-2002, 05:32 PM
|
#5 |
|
Registered Member
Join Date: May 2001
Location: Chattanooga, TN USA
Posts: 29
|
You don't have to take anything off to get to it. You just have to reach back behind the intake and pull it out.
 That picture is on a Holley intake...But you can see the hole that it will plug into. That is on the firewall side of the engine. You just have to reach back behind the upper intake and yank it out...should have a large hose coming out of that hole and the PCV valve is attached. It sits in a little rubber grommet. (spelling?) Chad
__________________
78 Regal (stock) 89 Mustang GT 25th Anniversary (parts purchased, but not installed) 93 Mustang LX 5.0 ex-FHP car (modified) 02 Camaro Z28 35th Anniversary (light mods) http://members.aol.com/chadtn |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve tap!! | SmokinStangGT | Windsor Power | 1 | 07-31-2003 03:42 AM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |