Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-25-2002, 12:41 PM
|
#7 |
|
Registered Member
Join Date: Nov 2001
Location: Mission Viejo,Ca
Posts: 37
|
One the drivers side of the upper intake there are two vaccum hose and one is running to the front of the upper and one is running to the back of the lower intake. Follow the the hose that goes to the back to the lower intake. When you get the the end of the hose pull up and the pcv should pop right out of the lower intake. IF you can,take that hose off the side of the upper intake that goes to the pcv. There's a little screen that the pcv sits in that should be removed with some needle nose pilars and cleaned with carb cleaner.
__________________
89gt,3.27's,Auburn,tremec 3550,Steeda tri-ax,aluminum driveshaft,Asp underdrives,Flowmast er 3 chamber,March ram air,130 amp alternator,Koni yellow struts,Kyb shocks,Pirelli p-6000's,MM's lower control arms and full length subs |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve tap!! | SmokinStangGT | Windsor Power | 1 | 07-31-2003 03:42 AM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |