Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-27-2002, 06:42 PM
|
#3 |
|
Registered Member
Join Date: Jul 1999
Location: INDIANAPOLIS
Posts: 404
|
The part you are refering to is an emissions pump. I have it and it works fine for me. I have no oil leaks or dipsticks blowing out. I did have a breather on the valve cover, but my blow by was bad enough that I had small oil droplets being pushed out. Now, its great, a clean engine again. The pump comes with 5/8" hose fittings. I didn't want to hack up my "go fast" chrome valve covers , so I drilled and tapped an old oil fill cap with a 3/4 MPT with a 90 deg end and a 5/8" hose on the other. Works great. Cost is about $180-120 depending on the dealer. I bought mine used for 70. Hope this helps.
__________________
old S trim combo 10.13@ 135 New YS combo = 680RWHP (no times) |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Confused, I need help on different fuel pump wiring methods. | 5.0 Fiend | Windsor Power | 12 | 10-14-2004 06:43 PM |
| oil pump installation question | 82 GT | Windsor Power | 3 | 07-03-2003 02:03 PM |
| Fuel pump relay questions | Big Bopper | Windsor Power | 1 | 11-10-2002 10:20 PM |
| STEWART Water Pump issues :( ?? | LOBE_50 | Windsor Power | 6 | 05-15-2002 08:34 AM |
| Lost another oil pump | oldman | Windsor Power | 2 | 10-20-2001 11:14 AM |