Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-29-2002, 08:10 PM
|
#6 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
i havent done anything to my fuel system yet. i just bought 24# injectors (if anyone needs some let me know, abeer1220@hotmail.com).
i am going to get a MAF i just thought if the crane was a good deal for 15 dollars i may give it a try (so i just sent the check). what could i loose other than 15 dollars???? i dont have the money to get anything better at this point... thanks guys, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MSD or CRANE | Scrapla | Windsor Power | 6 | 05-23-2004 07:31 PM |
| Crane Coil | MidNiteBlu 5.0 | Windsor Power | 17 | 11-30-2002 06:17 PM |
| crane 2030 cam | 1985Mustang | Windsor Power | 2 | 12-18-2001 08:58 PM |
| crane cam dyno results are in ,kind of? | 46stang | Modular Madness | 5 | 12-04-2001 08:58 PM |
| Crane 2031 cam and Edelbrock intakes on, impressions..... | 93CobraR | Windsor Power | 4 | 05-23-2001 11:53 AM |