Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-30-2002, 05:55 PM
|
#6 |
|
Registered Member
Join Date: Oct 2000
Location: Saxonburg, PA, USA
Posts: 236
|
D&D K-Member kit was $649 from JD's Performance in Orlando, I ordered it with street A-arms(for the sway bar bracket) and drag coil overs. I was going to get the UPR chromoly setup but for some reason didnt. Will buy rear coil overs control arms to complete suspension.
Once I get the stuff in few days I will weld in sub frames and fully weld my upper control arm bracket since the passenger side one began to pull away this past season(about 3/16"). Will also weld up lower boxes while Im at it. Ah Im not worried about painting I can paint, weld and build some pretty nice motors plus all the other wrenching involved.
__________________
Ed.. My Mustangs webpage NMRA M/M 7222 2000 Mustang GT - 5 speed Race weight w/o driver 3086lbs, 3250 w/ driver Best 1/4mile run to date: 12.79@105.96, 60' 1.76sec.(10-27-02) Best MPH 106.03(10-27-02)4.10gears |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Return fuel line on 90 GT (UR .02 cents wanted) | BigCountryGT | Windsor Power | 2 | 03-15-2004 03:20 PM |
| just blew my motor | aford50lx | Stang Stories | 19 | 06-06-2003 09:59 AM |
| 255 LPH pump...return line pressure too high...ideas?? | 84LX89GT | Windsor Power | 1 | 05-12-2003 07:31 PM |
| Oh No She blew apart! | bri32zz | Blue Oval Lounge | 11 | 01-03-2003 07:05 PM |
| -8 feed line/ -8 return ???? | sn95gt19 | Windsor Power | 5 | 12-18-2002 08:03 AM |