Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-03-2002, 12:12 PM
|
#3 |
|
Registered Member
Join Date: Oct 2000
Location: Charlotte NC
Posts: 193
|
Shouldn't they have the PCV hooked up also. And to not have any breathers on the other side. I had mine set up like this and was informed by a reputable guy at our only speed shop that having just breathers on one side and the PCV on the other will cause a vaccume leak and could cause oil to be sucked out when the motor is idling such as in traffic. It seems to run better and not as rich like he said but I didn't understand the whole "sucking oil" story.
__________________
1969 fast back; yellow; weld wheels; 302 roller with GT-40 heads; 3:55 gears; 5spd T-5; MSD 6AL; E-303; flows; Hedman headers; Holley 600;Weiand Accelerator;1.6 rockers |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intake selection with a 383/408 stroker | Capri306 | Windsor Power | 12 | 05-03-2002 10:12 PM |
| Explore intake??????????? | William Bowers | Windsor Power | 2 | 02-14-2002 10:27 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |